place

Archer Lodge, North Carolina

1851 establishments in North CarolinaPopulated places established in 1851Towns in Johnston County, North CarolinaTowns in North CarolinaUse mdy dates from July 2023
Archer Lodge town sign
Archer Lodge town sign

Archer Lodge is a town in Johnston County, North Carolina, United States. Its population was 4,292 as of the 2010 census, and as of 2018 the estimated population was 5,014.

Excerpt from the Wikipedia article Archer Lodge, North Carolina (License: CC BY-SA 3.0, Authors, Images).

Archer Lodge, North Carolina
Covered Bridge Road,

Geographical coordinates (GPS) Address Nearby Places
placeShow on map

Wikipedia: Archer Lodge, North CarolinaContinue reading on Wikipedia

Geographical coordinates (GPS)

Latitude Longitude
N 35.690555555556 ° E -78.375 °
placeShow on map

Address

Covered Bridge Road 6678
27527
North Carolina, United States
mapOpen on Google Maps

Archer Lodge town sign
Archer Lodge town sign
Share experience

Nearby Places

Walnut Hill Cotton Gin
Walnut Hill Cotton Gin

The Walnut Hill Plantation cotton gin house was built in the mid to late 1840s by Alonzo T. Mial, a prominent planter and commission merchant in 19th century North Carolina. It is one of a few surviving cotton gin houses in the state, and is likely the only one to have retained the majority of its original ginning equipment.The gin house is a 2+1⁄2-story-tall, hand-hewn timber frame structure, approximately 36 feet (11 m) wide and 56 feet (17 m) deep. The frontmost two-thirds of the structure is supported by tall, 2 feet (0.61 m) thick granite ashlar pillars that form a square, open-air space on the ground floor in which the mule track and power shaft were located. The rear third of the gin house rests on short, granite rubble piers, and housed the ground-floor pressing and packaging rooms. Most of the ginning equipment resided on the second floor of the gin house. The third floor was used for storage of baled cotton. The gin was originally powered by two to four mules hitched to horizontal sweeps that turned the vertical power shaft. The power shaft was connected to a series of cog wheels that ultimately transferred power to the leather belt that drove the gin. In 1875, Mial replaced the mules with a 15-horsepower steam engine, which considerably increased the gin's production capacity. The gin house received a number of other upgrades as ginning technology progressed over the following fifty years. The Walnut Hill cotton gin ceased operation in the mid-1930s, shortly after the death of Millard Mial, Alonzo T. Mial's oldest son.